PVC Flooring Adhesive

B830 PVC Flooring Adhesive

B830 pvc flooring adhesive is mainly suitable for bonding various PVC plastic sheet floors and base layers in civil, commercial and industrial buildings. 

Key Features:

Floor tiles with adhesive has good initial adhesion and high final adhesion strength;

Elastic bonding, long-lasting and effective, ensures stable and long-term performance of floor materials

Easy to construct, large coating area

Non-toxic and harmless, green and environmentally friendly

 

 

Color	Cream
Appearance :	Colloid is uniform, without agglomerates
Adhesion strength :	≥0.30Mpa
Waiting time :	About 10 mintues（depending on the weather）
Construction time	About 72 hours
Theoretical dosage:	250g/m2 -300g/m2

                  

           

---

Base Treatment:

• The base must be clean, dry, flat, solid, without structural defects, and without materials that affect bonding.
• Low-strength or sandy surfaces must be sealed with a multifunctional water-based primer. Non-absorbent bases such as tiles are recommended to be primed with a non-absorbent primer.
• For uneven bases, it is recommended to use self-leveling cement series products for leveling (see the product manual of this series for specific construction).
• The moisture content of new concrete, mortar layers, etc must be tested. Construction is prohibited if it is higher than 4%, or an epoxy moisture-proof primer system should be used for protection.

• Stir thoroughly before use. It is recommended to use A2 or A3 serrated scraper to evenly apply and spread.
  The drying time is 5-30 minutes. When the color of the film becomes transparent, the above floor materials can be laid.
• After the floor is pasted, use cork or a roller with more than 30Kg to roll to ensure that the adhesive vinyl tiles floor is fully attached to the back of the floor.
• For floors with special requirements, follow the instructions provided by the flooring supplier.
• It will be basically cured after 24 hours and can be walked on after 48 hours.

Storge

• The floor tiles with adhesive should be protected from high temperature and sunlight during transportation, storage and construction
• The storage room temperature in winter should be higher than 0 degrees Celsius
• The construction temperature should not be lower than 5 degrees Celsius.
• This product is not suitable for outdoor use
• Tools can be cleaned with water before the glue dries.